I n k a r p

The BWB BIO AV Flame Photometer

The BWB BIO AV Flame Photometer

Purpose Built Flame Photometer with specialised software, firmware and hardware

  • Specially configured for a range of user interests
  • “IRS” (internal reference standard) caesium or lithium option
  • single point calibration correction
  • internal reference standards
  • 10k ppm calibration standards for each element
  • Analysing li, Na and K
  • operator independent determination of results
  • advanced automated determination of results
  • integrated printer with environmentally friendly ink
  • IQ, OQ, PQ web-based certification standard on bio and available on all BWB FES units
  • Technical Data
Sample rate 2 – 3.5ml/min
Tubing materials Silicone and Tygon®
Specificity Na/K/Li = <1% to each other when
equal in concentration at <100ppm
Required desk space for Instrument 50cm (H) x 45cm (W) x 45cm (D)*
For Safety reasons the Flame photometer requires 1m of unobstructed space above to allow dissipation of heat from the chimney.
Instrument size XP Flame Photometer
51cm (H) x 39cm (W) x 35cm (D)
(20in x 15in x 14in)
Shipping 65cm (H) x 49cm (W) x 43cm (D)
(25in x 19in x 17in)
Weight BIO Flame Photometer 14kg (30.8lbs)
Shipping 25kg (55.1lbs)
Optimal range Multi-point calibration
Na – 0.0043 – 300mmol/l*
K – 0.0013 – 200mmol/* 
Li – 0.0072 – 20mmol/l*
Ca – 0.025 – 20mmol/l*
*With required Dilution Ratios
Reproducibility < 1% Coefficient of variability for 20 consecutive samples over ten minutes at concentrations of 100ppm equivalent or less. (After instrument stabilisation).
Limit of detection (LOD) and
limit of quantification (LOQ)
Na – 0.0013mmol/l
K – 0.0005mmol/l
Li – 0.003mmol/l
Na – 0.0043mmol/l
K – 0.0013mmol/l
Li – 0.0072mmol/l
Time to stability Less than 15 seconds after sample
is introduced into the flame
Ions measured   Na, K, and Li
Recommended minimum warm up
time based on ambient temperature
21°C – 25 minutes
Power requirements 100V – 250V AC at 50 or 60Hz
Fuel requirement Propane, Butane or Natural Gas* regulated to 19Bar. Flow rate of 0.4l/min
*with modifications. BWB Technologies recommends either Propane or Butane for optimum results.
Readout LCD, four line, alpha numeric, back lit.


Upcoming Webinars

Reactor-Ready Recap: Scaling up Safely and Efficiently

Case studies in catalysis - success stories and tips for more efficient reactions